Page 1 of 1
Crank shaft pulley
Posted: 22 Oct 2026, 20:50
by welder kev
I removed the pulley to replace the oil seal ,and cant get the pulley back on the shaft,does the keyway move as it looks like its pushed back when i push the pulley on it doesnt locate on the keyway thing.
Sent from my SM-S942B using Tapatalk
Re: Crank shaft pulley
Posted: 22 Oct 2026, 21:03
by davidoft1
The key is floating and it’s easy to push it back if you don’t get the a lot lined up
Re: Crank shaft pulley
Posted: 22 Oct 2026, 21:14
by welder kev
Great thanks can i just get pliers on it and pull it back into position
Sent from my SM-S942B using Tapatalk
Re: Crank shaft pulley
Posted: 23 Oct 2026, 08:18
by silverbullet
Crank pulley key should be a tight fit. If its floading about then the engine may well have been run with a loose pulley in the past and its hammered the keyway out, more of a problem with the heavy triple pulley that has to be torqued up to c.350Nm