Club 80-90 Forums

Ive replaced all front brakes on my 85 t25 ,the metal pipe that goes to the flexi have snapped,so i need to replace them(both sides) but do i have to remove the fuel tank to do this, also where do they go to.thanks in advance and big thanks for all info regarding my dodgy id dilemma.

Sent from my SM-S942B using Tapatalk

There’s a T piece under the front , only a single line runs to the rear , I think the T piece is from left around the steering rack area , it’s a bit tucked away

Ok thanks would i need to remove tank .

Sent from my SM-S942B using Tapatalk

I changed both front hard lines earlier this year.
On nearside (assuming RHD and in UK) chassis, beyond wheel arch, is the tee piece. A short hard pipe goes to wheel arch and connects with flexi hose going to caliper. Easy job.

However, getting the offside hard line in place is a pain in the harris. It runs in front of the fuel tank and behind spare wheel holder. It takes a bit of bending, twisting and shaping to feed it through. Took about an hour of fumbling in the offside wheel arch.

Brickwerks sells preshaped hard lines.
Tape the ends to prevent ingress of wheel arch crap.

Thanks i tried just kampers but they sell all different lengths and im not sure which is which till i take them off

Sent from my SM-S942B using Tapatalk