Club 80-90 Forums

Folks, I’m trying to retro fit a floor heater pannel into my van.

Anyone have a set of the mounting bolts and rear vent ?

Are the vents supposed to connect to the heater box ?

Would welcome any input.

Thanks in advance

I wouldn't worry much about the fixing screws they are just long panel screws, the tubes aren't essential
Do you have the correct front duct 253 259 135, that is essential

I may have the metal trim for the rear end, I am not sure, will have a look later

Thanks Aidan, I don’t have the duct that provides for the floor heating.

Will put an advert in the wanted section.

Please let me know if you have a metal grill- pm me .

Kind regards

Have checked and no, sorry, I don't have the rear metal plate

Have to ask why you are doing this, and whether you have a three or 4 lever heater lever set up - it might not even be possible if you have the three lever basic version

Hi Aidan,

I have the three lever control.

I see the four lever controller has a control for the rear vent- did not know this.

Is a four lever controller a direct swop ?

My heater has not worked since I got the van so at sone point the dash is coming out in any event.


Kind regards