Page 1 of 2
PAS
Posted: 04 Dec 2025, 09:12
by R0B
Has anyone replaced the seals in a power steering rack? Is it an easy or difficult job?
Re: PAS
Posted: 05 Dec 2025, 10:52
by Aidan
There's a thread on Syncro a few years ago, but I'd just send it to a little specialist in the South West and have them do the job, easy it is not.
Re: PAS
Posted: 05 Dec 2025, 12:03
by R0B
Thanks mate. I had a quote of £250 from one company and wondered if a DIY was possible.
Re: PAS
Posted: 05 Dec 2025, 14:23
by Aidan
KELLY BRAY STEERING is the company I was meaning - did one for me back in 2022. The company I used before in the West Midlands ceased trading during covid
I asked Baxter and he'd never found a long term repeatable reliable company hence not supplying them on exchange, apart from the problems of peeps not sending cores or cores being beyond repair
Re: PAS
Posted: 05 Dec 2025, 16:50
by R0B
Thanks. I have sent them a message.

Re: PAS
Posted: 08 Aug 2026, 13:12
by T3luestar
Just reviving this thread, as my power steering rack has developed a leak and filling the gator with fluid. Did you manage to get yours refurbished and by who?
Re: PAS
Posted: 08 Aug 2026, 14:09
by R0B
I never got it done, it's a spare one I bought and was asking in case it needed refurbishing at some point.
Re: PAS
Posted: 08 Aug 2026, 14:17
by T3luestar
Cheers for the reply.

Re: PAS
Posted: 08 Aug 2026, 14:23
by clift_d
We had our rack refurbished at Kiley & Clinton in Birmingham on the basis of multiple recommendations. I can’t comment on how it’s performed yet as we’re finally having it fitted to our van next week, but they were very professional to deal with.
Re: PAS
Posted: 08 Aug 2026, 14:27
by R0B
How much did it cost Daniel?
Re: PAS
Posted: 08 Aug 2026, 14:33
by silverbullet
clift_d wrote: ↑08 Aug 2026, 14:23
We had our rack refurbished at Kiley & Clinton in Birmingham on the basis of multiple recommendations. I can’t comment on how it’s performed yet as we’re finally having it fitted to our van next week, but they were very professional to deal with.
K&C are a proper firm, been around since forever, I wouldn't hesitate to go there.
The thing that kills PAS racks is dirty working practices when renewing pumps and hoses. Grit gets into the system on the wrong aude of the filter i the reservoir and then scores the piston tube.
Re: PAS
Posted: 08 Aug 2026, 14:33
by silverbullet
R0B wrote: ↑08 Aug 2026, 14:27
How much did it cost Cliff?
Daniel

Re: PAS
Posted: 08 Aug 2026, 14:39
by R0B
Edited
Re: PAS
Posted: 08 Aug 2026, 14:53
by clift_d
My recollection is that it was around £250-£300, but that was a couple of years back. No harm in giving them a call. They obviously require a unit to rebuild, and they’ll assess it thoroughly for suitability before they start.
Re: PAS
Posted: 08 Aug 2026, 14:57
by R0B