Page 1 of 1
looking for a part.........
Posted: 29 Mar 2007, 11:21
by macthejaffa
hi all.......i'm looking for whatever it is that goes between solex 34 pict carb and inlet manifold heater.....a mech that cleaned the carb out said it was all split so he wacked a load of sealant on there as a temp fix.....however air is getting in there and causing probs on warm up so I need to get a new 'un....can't seem to find one anywhere though !!
any ideas much appreciated
happy chuggin'
Posted: 29 Mar 2007, 12:23
by clartsonly
hmmm problems on warm up your say.
http://archive.club8090.co.uk/viewtopic.php?t=17358
I noticed mine was split too and has problems during the warm up, eg 10 miles or so needed to stop it stalling at junctions.. If you read down the thread apparently GSF do this thick rubber flange much cheaper than the £50 VW want for it.. if it is for a DG engine I have the bit at home, but it is not the big rubber flange bit I reckon you have like me.
actually based on your issues I have just ordered one from GSF now

Posted: 04 Apr 2007, 12:30
by clartsonly
damn, replaced part... still stalls when warming up
although at least the carb now moves with the engine rather than being all floppy on top of it.
Posted: 04 Apr 2007, 12:59
by Mocki
if its stalling when warming up adjust the choke..
Posted: 04 Apr 2007, 21:43
by clartsonly
I am not sure you can adjust the choke on a solex?