No reverse gear - missing something obvious I’m sure
Posted: 22 Oct 2023, 15:18
Hi,
Just to check I am not missing something obvious to brighter minds…
I’ve just rebuilt the rear gear selector with new cup etc, and the gears were ok, although second / third seemed a little off. So I adjusted the splines so that the forks sit tidy as per the wiki. All the gears seem to slide into the slots fine, so was feeling good about myself. Foolish.
Now when I pull reverse, I am just getting a forward gear (presumably first?). The van moves forwards. All gears seem to engage when I work the box (although Sat on the driveway so can’t be sure they’re right), and reverse seems to be in the correct slot.
Any likely places to look, or do I just run through the process again? One thing I did notice was the splines seemed to have about 12mm showing, not the 8-10 recommended, but as they had been like that before I didn’t think to change them.
Any thoughts? 86 1.6D, 5 speed.
Many thanks in advance.
Just to check I am not missing something obvious to brighter minds…
I’ve just rebuilt the rear gear selector with new cup etc, and the gears were ok, although second / third seemed a little off. So I adjusted the splines so that the forks sit tidy as per the wiki. All the gears seem to slide into the slots fine, so was feeling good about myself. Foolish.
Now when I pull reverse, I am just getting a forward gear (presumably first?). The van moves forwards. All gears seem to engage when I work the box (although Sat on the driveway so can’t be sure they’re right), and reverse seems to be in the correct slot.
Any likely places to look, or do I just run through the process again? One thing I did notice was the splines seemed to have about 12mm showing, not the 8-10 recommended, but as they had been like that before I didn’t think to change them.
Any thoughts? 86 1.6D, 5 speed.
Many thanks in advance.