Club 80-90 Forums

https://www.alanhschofield.com/    https://brickwerks.co.uk/product-catego ... ir-panels/

Ahschofield I think... or brickwerks might do the panels

A H Schofield has a few types , the one that looks the best potion is 251809559 Correct sill and side panel, it doesnt say if it extends in to join with the floor like the original but if you have a welder he will make it work.

multisi wrote: ↑14 Aug 2023, 14:26 A H Schofield has a few types , the one that looks the best potion is 251809559 Correct sill and side panel, it doesnt say if it extends in to join with the floor like the original but if you have a welder he will make it work.

That’s only an outer sill it’s cover panel rather than a replacement

Looks like you need outer sill, lower side panel , inner floor panel, what’s the inner sill like?

davidoft1 wrote: ↑14 Aug 2023, 14:42

multisi wrote: ↑14 Aug 2023, 14:26 A H Schofield has a few types , the one that looks the best potion is 251809559 Correct sill and side panel, it doesnt say if it extends in to join with the floor like the original but if you have a welder he will make it work.

That’s only an outer sill it’s cover panel rather than a replacement

Have you looked at the 2 photos of this panel ?
 

I don’t want to be the voice of doom (but if the cap fits, I’ll wear it!) but you’re as well to hear this now rather than from your welder once he’s started stripping it.

You may easily have much more rust than you can see. As noted above, how’s your inner sill? How are the front and rear ends of the sills where they interface with the jacking points and B and C pillars?

I had my drivers inner and outer sil along with rear arm bracket done with the floor section in 2019, was about 1.5k all in..

Check to make sure your window drains are clear, blocked drain holes was what blew out my sil and floor.

multisi wrote: ↑14 Aug 2023, 15:12

davidoft1 wrote: ↑14 Aug 2023, 14:42

multisi wrote: ↑14 Aug 2023, 14:26 A H Schofield has a few types , the one that looks the best potion is 251809559 Correct sill and side panel, it doesnt say if it extends in to join with the floor like the original but if you have a welder he will make it work.

That’s only an outer sill it’s cover panel rather than a replacement

Have you looked at the 2 photos of this panel ?
 

I have it’s not what i would call a replacement, it’s a repair panel , i wouldn’t fit one

He is looking at repairing the lower side , thats what that repair piece is for.

Buy the fridge panal. Use the outer lower sill . we make the inner closure that joins the outer 2 to the floor .nice easy way to do them benefits are all welding or most are plugs spots .the oters can be clamped with grips .horoizontal alinment is easy .i can stick some picks up if needed.
mm