Club 80-90 Forums

Evening all !

I have a 1988 1900cc petrol t25 that has sat for 7 years. Along with alot else my plan is to drop and flush out the tank prior to attempting to start it up, with this I'd like to replace the old fuel lines to and from the carb, cross over pipe, the lines up to the expansion tanks aswell as the fuel filter and pump.

I obviously want to go with ethanol safe pipes but do I reuse the hard formed plastic pipes or run it all in one hose , also it looks like the new pump in and out pipes are different size.

Any advice on what to use or what others have done would be massively appreciated! main priority is its all safe for the wife and little one so want to do it properly.

Thanks Brock

Evening , welcome .
There is no need to replace the hard plastic fuel lines as long as they are not damaged , and are visually ok . You did need to change all the rubber pipes , without a doubt , and dont be tempted to buy from camping shops or cheap ebay rubbish
Brickwerks do a full kit . Remember you should only have one filter , located down by the tank exit .