Club 80-90 Forums

Advice Please:

My T25 leisure battery is dead. Well actually I've had the battery out and recharged it but still no use. No water pump gauge or internal lights or anything that runs off the battery is working. What might be causing this? Could it be a fuse?

Any thoughts welcomed

Thanks
 

Have tested the battery voltage after recharging? It could be its died.

[size=100][font=Calibri,sans-serif]Thanks for replying. I've tested the battery and it's fine. Having had a poke around I found this disconnected Blue cable under the passenger seat - Any thoughts on what this is and if it might be the problem?

(trying to wok out how to add a picture...)[/font][/size]
 

Have you checked your fuses

Thanks All - So this is the cable that I have found underneath the passenger seat. Should this be connected or is this redundant?
Regarding Fuses - any advice on which fuse I could investigate?

Thanks all for your help

Best thing to do is trace where the other end is.

it goes towards the front of the van by the steering column. So I'm thinking isn't to do with the leisure battery? Where would I find the fuse for the Leisure battery - is it with the other fuses in the glove compartment?

Thanks
 

Your fuse is on the right of the pic!
That spare wire could be for the radio so that it doesn't drain the starter battery.

Thanks for all the help here. The radio does actually drain the starter battery - where should that cable be terminated?

Is the fuse therfore the pink thing? (sorry!)

PenelopePitstop wrote: ↑03 Feb 2023, 09:58 Thanks for all the help here. The radio does actually drain the starter battery - where should that cable be terminated?

Depends on the radio. Check the radio connector diagram. Usually there is a sticker on the radio itself.
Memory feed should be connected to battery positive, power feed to key in or ingition on positive

Where on the back of the fuse box multi plugs could you connect 1 wire from the leisure battery fuse box to run interior light,stereo and cig lighter?

Easiest way , if you have the new blade fuses is to use one of these https://www.ebay.co.uk/itm/164847231745
In the fuse 3 position .

Thanks All - Looking at all suggestions

Yes fuse 3 feeds all those circuits.