Club 80-90 Forums

Any thoughts on what I can tidy this up with?




Sent from my iPhone using Tapatalk

I have seen someone use a fire blanket on some other posts.

Sent from my motorola one action using Tapatalk

I used insulation on a roll. A bit like aluminum foil bubble wrap. Been on there about 3 yrs now stuck with spray glue.

https://www.screwfix.com/p/ybs-airtec-d ... 1-5m/50913

This sort of thing, just to give you an idea. A lot of waste there though unless you fancied using the rest to do your van!

Thanks both! That’s helpful


Sent from my iPhone using Tapatalk

Has anyone done this on a fibreglass engine lid as there are no wires to hold it in place??

Sent from my SM-G973F using Tapatalk

The GRP lids have molded foam insulation with built-in chickenwire reinforcement. Remove at your peril, it should be fire retardant. Better to fix some thin foil faced foam inside the van, then it can't come unstuck and drop onto the engine