Club 80-90 Forums

hi i have upgraded my clocks as the pcb was knackered but now the oil light flashes just once where before it used to flash repeatedly until engine start up, its a 1.9 watercooled on a c reg 86 and the kit was from slaughter house customs anyone had this?? want to take trip soon but want to check its good to go with no issues.
 

i have this same thing with my upgrade kit too (also from SHC). sometimes it does flash multiple times but 90% of the time it just flashes once and goes off.
it does still work though as when my Buzzer comes on the oil light is illuminated too.
has been this way for about 8 months since i fitted it

thats good to hear wanted to head down to Devon on the weekend but was worried wouldnt see if there was a problem until too late!! probably over worrying as first trip out. thanks for the reply 

ive taken mine from west london to devon once and then to cornwall on another trip.  Am no mechanical / electrical guy as i'm new to this all myself but it seems to be ok with the light going straight out:)
 

Recently had a dash to repair with this fault following the SHC upgrade.    There is a jumper that needs to be set depending on wether the van has the later DOPs System or the earlier simple oil pressure warning.    The Jumper should be across pins 1 and 2 for late vans or pins 2 and 3 for early vans.     Picture shows jumper in the correct position for late vans with DOPS.

ooh thats good to know! thanks
will have a check of mine over the weekend and see how mines set.

I know an idiot that didn’t do this

southernscouse wrote:I know an idiot that didn’t do this

Anyone with issues following fitting the SHC kit, just give them a call. They're really helpful, and will sort you out.

Sent from my moto g(30) using Tapatalk

the settings has been changed on mine now and the light flashes as its meant to!
thanks Angelo!