Weber 32/36 DFEV Jet Sizes / emulsion tubes / etc
Posted: 28 May 2022, 13:21
Hi - I have a 1983 Vanagon 2l CU and it has a single Weber DFEV 32/36 conversion installed. I’m going to take it off and give it a full rebuild and whilst doing so, was going to make other amendments if required to jets and emulsion tubes.
I realise that best to take to rolling road but ideally there must be a “base set” that can work from and would be great if someone can share there knowledge please on this kind of info please?
Not able to switch to a dual carb setup so want to make this work for now. Also, if anyone has any images on throttle linkage to cable setup, that would also be appreciated as what’s there is a bit heath Robinson.
Thanks,
Joff
I realise that best to take to rolling road but ideally there must be a “base set” that can work from and would be great if someone can share there knowledge please on this kind of info please?
Not able to switch to a dual carb setup so want to make this work for now. Also, if anyone has any images on throttle linkage to cable setup, that would also be appreciated as what’s there is a bit heath Robinson.
Thanks,
Joff