Club 80-90 Forums

Hi everyone, I’ve removed a roof rack that came fitted to my double cab Doka and to my surprise it has either had 2 sunroof’s (front and rear)
Or… the front removed and fitted in the rear.

The tell tale is there appears to be a shady sheet metal skin the shape and size of a sunroof over the drivers cab part and a sunroof over the rear passenger part.

So few photos exist I’m at a loss (without removing the headlining) as to what could have been OEM.

Question is; are double size (think BMW mini or beetle rag top) sunroof’s a thing for the Doka?


Also appears my rear one doesn’t open :,(


Sent from my iPhone using Tapatalk

Hard to tell, looks like someone stuck the roof rack back on while your back was turned

front could be factory, they have internal drainage system and winder operated by big grey knob (not the driver  )
part number was 251 877 051, Google is your friend

looks like this

factory sunroof sit almost flush to the roof compared to aftermarket ones and as said they have four tubes from a rain gully. one on each corner.
I have one in the garage complete with most of the cab section of roof if anyone wants one.

t25adict wrote:factory sunroof sit almost flush to the roof compared to aftermarket ones and as said they have four tubes from a rain gully. one on each corner.
I have one in the garage complete with most of the cab section of roof if anyone wants one.

Please please please give me a call or DM me if you can? I think my roof is daffy ducked.
Regards, William


Sent from my iPhone using Tapatalk

to save you loads of spam calls I would remove your number from your post. I can get some pictures, mine is from a caravelle. its  quite a big section of roof but not enough for a complete crew cab roof.

t25adict wrote:to save you loads of spam calls I would remove your number from your post. I can get some pictures, mine is from a caravelle. its  quite a big section of roof but not enough for a complete crew cab roof.

No worries and cheers for the heads up- I see there is no direct messaging function on this forum? Or maybe just as I’m new, odd either way.

It’s mainly the front section I need, I’ll post a photo on Tuesday- just looks a state. (Front section to the top of the windscreen)


Sent from my iPhone using Tapatalk

let me check if I still have a picture of it. may well do.
 

this is the section that I have

t25adict wrote:this is the section that I have

I’m guessing that’s the front section to the windscreen?
And if so, how much and where (ish) in the Uk are you?


Sent from my iPhone using Tapatalk

Hi yes it has a short little stub of A pillar each side at the front. It was cut on the A pillars and then across the roof near by or in front  of the B pillars, gutter sections each side are still there. 50 quid ono


 

t25adict wrote:Hi yes it has a short little stub of A pillar each side at the front. It was cut on the A pillars and then across the roof near by or in front  of the B pillars, gutter sections each side are still there. 50 quid ono


 

Cheers for that, any chance of a photo and a length to the cut- I’ve got to measure mine in the morning to where the stamped out section is to see if it’s a feasible repair using your section


Sent from my iPhone using Tapatalk

hi I presume you are talking about the raised bump in the roof that lines up with the B pillars.

my section is cut about 30 - 40mm in front of that bump.  So there is 800mm ish of flat roof then the short angled bit that turns down towards the windscreen. 

t25adict wrote:hi I presume you are talking about the raised bump in the roof that lines up with the B pillars.

my section is cut about 30 - 40mm in front of that bump.  So there is 800mm ish of flat roof then the short angled bit that turns down towards the windscreen. 

That’s doable I think, my bump/hump looks in fair condition, it’s the area from there to the screen that looks the worst- doesn’t look it but the double cab Doka roof is almost 6ft, bigger job that I expected.

Still talking to my engineers to see if they can collect it for me.


Sent from my iPhone using Tapatalk