Grease on gearbox input shaft
Posted: 29 May 2021, 09:46
Hi all, I've tried asking on Facebook in a couple of places, and looked through the forum here, but I still don't have a definite answer.
When changing the clutch, should I grease the splines of the input shaft?
I have cleaned bell housing, pulled flywheel, checked endplay, replaced o-ring, replaced main seals on engine and gearbox, new spigot bearing, lubed, new felt grease seal, and a little grease on the end of the input shaft.
When changing the clutch, should I grease the splines of the input shaft?
I have cleaned bell housing, pulled flywheel, checked endplay, replaced o-ring, replaced main seals on engine and gearbox, new spigot bearing, lubed, new felt grease seal, and a little grease on the end of the input shaft.