Club 80-90 Forums

Hi,

Does anyone know what thread size (diameter and pitch) the two bolts that screw into the hex bar on an EMPI dual carb linkage hex bar is?

Trying to get a couple of lock nuts. The pitch on the ball joint adjusters seems quite fine.


I do not have any lock nuts, so tried to order some. No joy. Guessing it's easier to simply order two lock nuts if you know what size and pitch thread you need.

Many thanks.

ask the supplier, they should know

Hi Aidan,

Thanks for your reply. I have contacted a couple, am still waiting for a reply.

Just wondered if anyone on here knew so I could get the nuts myself?

Thanks.