Club 80-90 Forums

So typical, both trailing arms have got quite a bit of rust on the outside bushing area.

I presume there are not supposed to be holes on the inside. Any recommendations on repairing these? I'm a self taught welder, OK on bodywork and basic joins but Is a repair even possible? Or should I get it done, or just face up to 600quid for two new arms!

Attached a couple of images, higher res here: https://imgur.com/a/rQLM8FB" onclick="window.open(this.href);return false;

Repairing the mounting side of the arms is not really a DIY thing. Its really hard to do it well if even possible.
So beside the new, good used ones are the solution

Thanks, Such a shame to throw away so much good metal, i'll get some new ones! Thanks!

https://forum.club8090.co.uk/viewtopic. ... 7&t=170889" onclick="window.open(this.href);return false;

Might still be available