Page 1 of 1
clutch judder Subaru conversion
Posted: 08 May 2020, 11:47
by jan
Hi all, hope your all keeping well in this challenging time. I have had a Subaru conversion done using a 4 speed Vw box. When pulling away there is a fairly serious judder when lifting the clutch, strangely its fine when cold but after a few miles it gets difficult to stop even when being very gentle. Thanks in advance for and ideas you folks may have.
Re: clutch judder Subaru conversion
Posted: 08 May 2020, 14:38
by Aidan
How is the conversion done ? RJES bellhousing, small car bellhousing, adapter plate ?
What's the flywheel and clutch set up, and which engine is fitted ?
Re: clutch judder Subaru conversion
Posted: 08 May 2020, 17:01
by jan
Its a Rjes set up using a new Subaru clutch. 2.0 turbo engine.
Re: clutch judder Subaru conversion
Posted: 08 May 2020, 19:16
by Aidan
turbo pull clutch or N/a push clutch ?
Trubo clutch is usually very digital either on or off and no slipping so ifs there is definately a spigot bearing fitted then I'd be worrying about the gearbox input shaft and or input bearing and or mainshaft bearing and or mainshaft bearing displacement - if box was tired and it's been launched or driven aggressively with the new engine and strong clutch
Which box is fitted ? What's it's history ?