Page 1 of 1
Final drive sump torque setting
Posted: 23 Jun 2019, 13:53
by Ciaoflyer
Anyone know correct torque setting for the sump on final drive attached to auto box? Ta
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 14:17
by 937carrera
Any use ?
.
diff_sump.jpg
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 15:57
by Ciaoflyer
937carrera wrote:Any use ?
.
diff_sump.jpg
Perfect but what is the bit about 5 mins?
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 16:02
by 937carrera
Zoom in, it says "Tighten diagonally, retorque twice more after intervals of 5 minutes"
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 16:15
by Ciaoflyer
937carrera wrote:Zoom in, it says "Tighten diagonally, retorque twice more after intervals of 5 minutes"
Super, so does that mean a total of 21ft lb?
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 16:19
by 937carrera
Not my reading.
Torque diagonally to the 10NM.
Let it settle for 5 minutes, then go around again at the same setting
Repeat.
I don't even have a torque wench that goes that low, and I have 4 of 'em
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 16:46
by bigherb
Yes it means to recheck torque again after 5 mins as the gasket will settle.
Re: Final drive sump torque setting
Posted: 23 Jun 2019, 18:05
by Ciaoflyer
Thanks so much guys!