Page 1 of 1
Best to buy a new panel?
Posted: 22 Oct 2018, 13:52
by Swebby
I was dealing with a bit of rust which called for me to take part of the rear bumper off. Managed to find a lot more rust!
My thoughts are it is probably better to get a new panel put in rather than cut out offending areas and weld. But any thoughts are welcome.
Sent from my BBB100-2 using Tapatalk
Re: Best to buy a new panel?
Posted: 22 Oct 2018, 16:19
by fazzer
Easy panel to replace I'd cut it out and all surrounding rot and put new panel in.
Re: Best to buy a new panel?
Posted: 22 Oct 2018, 16:24
by Swebby
Cheers. Do you know if it possible to get new wheel inner arch sealant like the original stuff? Seen some stuff on brickwerks but says it needs a special spray but they don't elaborate any further.
Sent from my BBB100-2 using Tapatalk
Re: Best to buy a new panel?
Posted: 22 Oct 2018, 19:42
by fazzer
I use stonechip in an aerosol can and put a few coats on it,leaves a nice textured coating.
Re: Best to buy a new panel?
Posted: 22 Oct 2018, 19:52
by Swebby
Sounds good, I will give it a go.
Sent from my BBB100-2 using Tapatalk
