Club 80-90 Forums

Just been under the van trial fitting sandwich plate, its a tight fit anyway and doesn't look as if I can can easily fit the sender unit for the pressure gauge.
Looks as if I could do with a spacer of some description to lift the plate away from the block, like the factory fit cooler on the 2.1DJ.

For the take off I'll have access to straight/45 and 90 degree bends.



Would it be ok to stack plates & centre adaptors?

Open to suggestions if anyone has any?

remote T piece

itchyfeet wrote:remote T piece

Could be the way forward, seen some an10 Male/female with inline take off for sensor - could fit at cooler itself.
I'll take another look on my day off with a spare filter and have a bit of a play around to see if I can manage to get it to seat to the block and use the take offs without resorting to another spacer plate.

BBB fitted a sandwich plate too - no adapters necessary I believe

https://club8090.co.uk/forum/viewtopic.p ... &start=438

937carrera wrote:BBB fitted a sandwich plate too - no adapters necessary I believe

https://club8090.co.uk/forum/viewtopic.p ... &start=438

Mine is a thermostatic plate and is slightly more bulky but will give it another go and see if I can get fittings to clear.

Yes, mine was just for senders not for take-off so it didn't take up as much space.

https://m.facebook.com/story.php?story_ ... 8728033184" onclick="window.open(this.href);return false;

Fitted to an early van, converted to DJ with external Laminova oil cooler. Btw, why do you want to fit a pressure sender here? Brickwerks remote kit is great for that.

Sent from my ONEPLUS A3003 using Tapatalk

Any chance you could post a link to the video / pictures that's not through farcebook?

I have the parts for a mocal / laminova setup ready and waiting installation on our JX van, and it would be good to see how you've set this one up.

ajsimmo wrote:Btw, why do you want to fit a pressure sender here? Brickwerks remote kit is great for that.

I didn't in particular - just thought it may have been an easy option. But now looking at it to relocate original sensor and add a T for new sender would be relatively easy and cheap using common parts.

Something like this with a length of copper pipe and M10X1.0 ends should work?

https://www.ebay.co.uk/itm/3-Way-T-Piec ... SwVW5bSM2y

clift_d wrote:Any chance you could post a link to the video / pictures that's not through farcebook?

I have the parts for a mocal / laminova setup ready and waiting installation on our JX van, and it would be good to see how you've set this one up.

Here you go. This is on an early wbx, so not sure how useful it is for a jx set-up.

Sent from my ONEPLUS A3003 using Tapatalk