Club 80-90 Forums

Not sure where to put this as it’s technically not technical lol.

Looking for some advice or just see how you guys go about cleaning the sliding window frames. I seem to get great results until they dry....then they look just as weathered as before.
I also tried products that would ‘feed’ a pourus surface with average results. But once it rained....back to square one.



Sent from my iPhone using Tapatalk

They look metal/ali(silver bits)? I'd try gently going at them with some light metal polish on a cloth. Or do you mean the rubber/plastic bits?

The metal frames is what I’m trying to cheer up a bit
They are anodised aluminium i think


Sent from my iPhone using Tapatalk

In my experience you will find that if the anodizing has degraded no amount of low level cleaning or polishing will return them to anywhere near acceptable appearance without first removing the anodized surface layer. I believe this can be achieved with sodium hydroxide and the internet will no doubt provide suppliers and methods. But be warned sodium - hydroxide caustic soda in the vernacular I believe, is an insidious hazard if used without extreme precautions.
In my early days I painfully lost several layers of fingerprints using a dilute solution which I only realized when the slippery slime appearing on my fingers turned out to be dissolved skin. And remember just polishing aluminium will involve regular re-polishing unless some kind of protective coating is applied.
If you embark on this please take extreme care with emphasis on safety glasses and appropriate protective gloves

I wouldn't use caustic soda for removing the anodizing - it will get into any joints and between frame seals etc. and rot away unseen aluminium, ruining them totally. I have used hot caustic soda for many years as a paint stripper ( numerous pine doors) and heavy duty oil/grease remover. It will also strip any wax on the paint leaving unsightly marks.