Club 80-90 Forums

Hi,
Done the usual prime then seam seal.. but the seam sealant has cracked, looks dry as well.. have redone it, but will probably scrape off and reapply..
Question is why..?
Have used the sealer before on my bug with no problems, the only thing I can think of is a reaction to the spray grey primer I used..
Anyone else experienced similar??
Thanks..

Only when I didn't remove all the old sealant

Ant-t wrote:Only when I didn't remove all the old sealant

This was brand new steel, just primed..
Strange..

out of intrest what sealant did you use?

dbz864 wrote:out of intrest what sealant did you use?

Was from wayside, used before with no problems.
I emailed them and they replied to say the most likely cause was the primer not being fully dried, not sure on that, was at least 24hrs between primer and sealant..
Oh well, scrape off, re paint and try again. Bought some tetrosyl to try as it gets good press..
Will post the results..