Club 80-90 Forums

Is the jet in the ball back to front?






Sent from my SM-G930F using Tapatalk

No

Ok thanks. I washed him and the jet was too low on the screen. Adjusted it and now nothing. Must be blocked I guess.

Sent from my SM-G930F using Tapatalk

Get someone to operate the washer while you prod it with a needle,that should flush any blockage out.

I would suggest using a pin rather than a needle - needles are brittle and can snap off in the jet easily. Been there and done that!

Blow the crud out with airline

But beware if the water tank is full as back pressure will soak the floor

Thank you for the advice.

Sent from my SM-G930F using Tapatalk