Page 1 of 1
starter motor bush 1.9dg
Posted: 03 Apr 2017, 06:54
by fazzer
Bought a new starter motor for my camper and all it does is click when ignition on,I've been told it may be starter Bush anyone know best way to remove old one.?
Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 08:13
by bigbadbob76
Run a tap up it and pull it out, M12 tap if I remember right but there's info on the wiki and searching previous posts will get you a more definitive answer.

Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 10:28
by fazzer
Thanks buddy will try tap,had 4 years of trouble free motoring now it's all goin wrong.happy days.
Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 12:16
by T3luestar
Don't forget to soak the new one in oil over night.
Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 13:25
by fazzer
Will do mate thanks

Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 21:06
by Sir Brixalot
With me it was a dodgy ignition switch, twice. Can't see which gear box you have but automatics don't have a bush.
Re: starter motor bush 1.9dg
Posted: 03 Apr 2017, 21:14
by IndigoSteve
T3luestar wrote:Don't forget to soak the new one in oil over night.
Not the starter motor - the bush.
I used a 12mm tap. Wind it in and keep turning. It will draw out the old bush. You don't need to pull on it
Sent from my iPad using Tapatalk
Re: starter motor bush 1.9dg
Posted: 04 Apr 2017, 07:05
by slowcoach
IndigoSteve wrote:T3luestar wrote:Don't forget to soak the new one in oil over night.
Not the starter motor - the bush.
I used a 12mm tap. Wind it in and keep turning. It will draw out the old bush. You don't need to pull on it
Sent from my iPad using Tapatalk
Also as i remember, helps if your arm is as flexible as a piece of rope, and you can see round corners , plus a black belt in yoga
Sent from my MotoG3 using Tapatalk
Re: starter motor bush 1.9dg
Posted: 04 Apr 2017, 17:42
by fazzer
The m12 tap worked perfectly,does the Bush need to go all way in to the end or just till flush with edge.
Re: starter motor bush 1.9dg
Posted: 05 Apr 2017, 19:45
by fazzer
After fitting new starter motor and new starter bush all I get when I turn the key is a clicking noise from the relay in the black box in the engine compartment 1.9DG,is this normal.
Re: starter motor bush 1.9dg
Posted: 05 Apr 2017, 22:15
by IndigoSteve
Check your voltage at the starter motor when someone turns the key for you. Sounds like you have a voltage drop - try charging the batteries. If the voltage is good and you have charged the batteries then check the earth - clip 2 jump leads together then clip 1 end to the neg terminal on battery and 1 to the engine somewhere near the starter motor
Sent from my iPad using Tapatalk
Re: starter motor bush 1.9dg
Posted: 07 Apr 2017, 10:36
by fazzer
Thanks mate turns out battery was knackered .
Re: starter motor bush 1.9dg
Posted: 09 Apr 2017, 18:02
by IndigoSteve
Glad you tracked it down
Sent from my iPad using Tapatalk