Eberspacher Problem
Posted: 30 Jan 2007, 21:14
I am having problems getting my B2L petrol Eberspacher to work properly. I have read wiki and all the threads and carried out some initial checks as advised in them, I also have a manual.
It will start up and operate correctly for a few minutes, running hot. The blower speed/heat reduces then shuts down completely. The longest it ran correctly today was for about ten minutes. I have tried it numerous times with the same results. On a couple of occasions it produced white smoke and once brown smoke. It will fire up each time but the heat is intermittent.
I have been starting the heater with the engine on to give it the correct voltage plus I know the Leisure battery is defective and will be replaced shortly.
The fuel pump is working fine and I removed the Glow plug and gave it a wipe, it had a slight coating of carbon. The electrical connections appear ok. On removing the plug I noticed there wasn't an atomiser/gauze screen. Would it be wise to replace the plug?
I have also checked the outlet and it's not obstructed.
I have no Eberspacher dealers nearby other wise it would have gone in for a service.
Any advice would be greatly received before I start seeking professional help.
It will start up and operate correctly for a few minutes, running hot. The blower speed/heat reduces then shuts down completely. The longest it ran correctly today was for about ten minutes. I have tried it numerous times with the same results. On a couple of occasions it produced white smoke and once brown smoke. It will fire up each time but the heat is intermittent.
I have been starting the heater with the engine on to give it the correct voltage plus I know the Leisure battery is defective and will be replaced shortly.
The fuel pump is working fine and I removed the Glow plug and gave it a wipe, it had a slight coating of carbon. The electrical connections appear ok. On removing the plug I noticed there wasn't an atomiser/gauze screen. Would it be wise to replace the plug?
I have also checked the outlet and it's not obstructed.
I have no Eberspacher dealers nearby other wise it would have gone in for a service.
Any advice would be greatly received before I start seeking professional help.