Club 80-90 Forums

Hi All
Does anyone know where I can get hold of any wiring data? My current problem is no reversing lights. Garage have checked lights and switch - all OK, no 12v to switch, apply separate 12v supply and lights work. I checked fuse box and fuse OK, but no 12v on either side of fuse, I assume this comes from the ignition switch but I don't know. Any ideas??
Regards
Ward

If it's the same as a '94 2.6, the reverse lamp circuit is:

Battery pos at relay plate > Fuse S14 > Pin F6 on relay plate > grey/white wire > reverse switch > black/blue wire > T28/9 (in engine bay) > black/blue wire in engine bay harness > L&R lamps

At the switch, with a meter, you should see battery pos (volts) on the grey/white wire and the bulb filament resistance (ohms) on the black/blue wire.

I have a pdf of 1994 2.6i wiring diagram, PM me your email address and I'll send you a copy.

Thanks to the two of you, I'll check from Synchroandy's data over the weekend and look forward to marlinowners diags.
regards
ward