Pas query
Posted: 25 Oct 2016, 20:37
Can anyone confirm if a pas pump and pulley from a 2.1 will fit a dg? Many thanks.
Yes.
Longer answer also available.
Page 1 of 1
Re: Pas query
Posted: 25 Oct 2016, 22:05
Re: Pas query
Posted: 25 Oct 2016, 22:43
ajsimmo wrote:Yes.
Longer answer also available.
Cheers chap.
longer answer much sought after.....Re: Pas query
Posted: 26 Oct 2016, 07:03
yyyyyyyyyyyyyyyyyyyyyyyyyyyyyeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeessssssssssssssssssssssssssssss
there you go
there you go
Re: Pas query
Posted: 26 Oct 2016, 07:48
Ha! 
I set 'em up...
So, the longer answer is Yes, they will fit. But ignore the 10 deg timing mark on the DJ pulley (remark it at 5 deg BTDC), and you'll need the matching pulley bolt, and do it up much tighter, and your o/s head must have the 3 posts drilled and tapped out for the pump carrier (if not, it can be done in situ - as I found out one day when fitting an engine in my pickup without giving this a thought beforehand!
What made it worse was the other head had the holes! ).
I set 'em up... So, the longer answer is Yes, they will fit. But ignore the 10 deg timing mark on the DJ pulley (remark it at 5 deg BTDC), and you'll need the matching pulley bolt, and do it up much tighter, and your o/s head must have the 3 posts drilled and tapped out for the pump carrier (if not, it can be done in situ - as I found out one day when fitting an engine in my pickup without giving this a thought beforehand!
What made it worse was the other head had the holes! ).Re: Pas query
Posted: 26 Oct 2016, 19:45
Cheers AJ, I do recall reading one of your posts about this done time ago. So, as well as the pas components, it looks as though I'll need to gather more pics of where the holes need tapping. Many thanks.