Page 1 of 1
END FLOAT PLAY
Posted: 22 Aug 2016, 17:27
by drjsmithwhite
How much play should there be with shims and fly wheel removed
Seems to move quite a bit so don't wanna no spend money on shims etc if there's a deeper lying problem
Re: END FLOAT PLAY
Posted: 22 Aug 2016, 17:41
by itchyfeet
Asuming you mean WBX don't force it with flywheel and shims removed, it means nothing anyway.
refit flywheel and shims then measure.
Re: END FLOAT PLAY
Posted: 22 Aug 2016, 17:51
by drjsmithwhite
Yeah sorry 1.9dg wbx
Ok I'll get some shims and re measure
Brought the engine with a supposed rebuild but no proof and it's now questioning the quality of the rebuild if the end float play hasn't been set
Seems to move quiet a bit currently but as I say that's without shims seal or flywheel
Re: END FLOAT PLAY
Posted: 22 Aug 2016, 19:14
by itchyfeet
Didn't it come with shims?
if not use the shims from your old engine then measure.
Re: END FLOAT PLAY
Posted: 24 Aug 2016, 07:30
by bigherb
drjsmithwhite wrote:
Seems to move quiet a bit currently but as I say that's without shims seal or flywheel
It will. It is the shims and flywheel that stop it moving too far.