Club 80-90 Forums

about 12 months ago i pulled my engine apart, last weekend i decided to put it all back together again and today its back in the van
not enough juice in the battery to see if it runs or not, but can't for the life of me remember where the vacuum pipes all go! can anyone do a simple drawing or take a picture of theirs so i can see

many thanks

This should do you I hope - it's not actually mine but the pipes are the same - pipe from cone side of diz vac unit goes to left carb, other pipe goes to the balance pipe/idling circuit at the back next to the bulkhead.


There is one on the Wiki but the pipes miss out the module on the aircleaner.

thanks keith, just what i needed

thats my engine on the wiki, should the vacuum pipes be like the picture above, what the difference in both ways?

Now I've got round to putting up a pic of my own engine you can see how the pipe that goes to the retard take off at the back of the engine "Ts" off to the little (heat sensor) module on the airbox, the other side of which goes on to the flap mech on the air intake - I'm fairly certain that this just ensures warm air is taken in on cold days and cold air on warm days - probably not too critical in our benign climate. Anyway alot of our engines don't have the little insulated duct on the bulkhead tin that takes air from near the heatexs and sends it up to the air intake - mine didn't until I fixed it - it was a heap of rust.
[/img]