Club 80-90 Forums

I know I'm slow but, try as I might I can't find an answer to this question in WIkI. I'm buying a run of units made for the T25 and also intend to fit y the Smev 9222 Sink and hob unit as well. I've checked the dimensions of the sink/hob combo and I don't seem to have enough length before the edge of my wooden (Westphalia I think) 3/4 r n r bed. From the front of the battery box until the forward edge of the bed is 886mm and all the units I've measured/checked are approx1120mm, can anyone offer some help please. Regards Rob

P.S. the gap between the side wall of Doris to the edge of the bed is 368mm

Camping right now and have tape measure so can measure mine. Westy kitchen unit is 900mm wide and bed when down comes up to it .

The front face of the seat base is about 350mm behind the kitchen unit, and the cabinet behind the kitchen unit between seat and wall is about 420mm deep. The kitchen unit sides stick out 20mm from this so you might get away with wider kitchen units if the bed can still pull out in front of it.

Cheers Pirate-Pete, I've since re-positioned the R&R bed, that is raised it slightly and gained another 75mm. I might now build my own units to fit the space. I replaced the carpet in the bus with some oak flooring, I'm quite pleased with it. Thanks again mate. Rob