Club 80-90 Forums

To complete my oil pump checking job properly I've been advised to fit the proper nuts to the plate, as I just had normal nuts. I've got a set of these:



So my question is, which way round do these go? Does the red ring go against the plate of the oil pump? It's for a DG 1.9.

Thanks

Mark

yes red ring to plate

I use standard nuts and yellow head nut sealant

Standard nuts and yellow head sealant too because it's normally available at the time of the build.


Sent from my iPhone using Tapatalk

I use stainless nuts and m8 dowty washers (these have a bonded rubber inside seal.)