Club 80-90 Forums

Both my door Windows wobble from side to side (fore - aft) once the have been wound down, the more they're lowered the greater the amount of 'play'. The regulator bolt at the bottom of the door is tight, the felt pads are in place and yet they wobble. Is this a problem within the regulator? Many thanks.

Anyone? I bet some of your windows do it too.....

Have you looked to see if the closed cell foam buffers are still within the door? I have one missing and will need to replace it before I finish my restoration.
If you take the door card off, you should see it just above the lock mechanism. This stops the window glass from moving backwards and forwards when in the down position.

This shows the foam block;



and this shows the window glass sliding past the foam;



Have not had time yet to see if they are still available yet.

Could also indicate wear in the window seal channels up the front and back of the glass.

So THATS what guides the window when its lowered. Thanks woodyyellyow for that. Actually, it doesn't look difficult to cut a new one.

Foam blocks are in place and have just replaced the window seals so it's none of those, many thanks though

bolt misssing from window mech?
happned to me

itchyfeet wrote:

Already checked that after witnessing yours. Ta.

itchyfeet wrote:

What's happened to your felt squares?

I image the felt didn't last long after the bolt fell out.




Sent from my chair in a field.

Thank you Woodyellow for this bit of useful info. Now to buy a piece of foam.

As I need to make new foam for the O/S, today I removed the one I have to take some measurements.
This is the foam as removed



And here is a quick drawing I’ve made from it, remember that these are the sizes of a 30 year old block of foam and should only be used as a guide!



As for finding the foam to make it from, I would have thought that the type of foam that is sometimes used as packaging around new televisions or the type of foam used in “cut out” protective cases for things like the GoPro.
Hope this helps others, just remember that the drawing shows the N/S foam, you will need to reverse the drawing for the O/S as they are “handed”.

John



ps. Forgot to say that the angle of the slope is 60 degrees.

Nice free hand isometric drawing
Dimensions in millimeters
French 7's




Sent from my sofa using My Tablet on Android 35% battery power.