Club 80-90 Forums

Hi Guys,

Basically ive bought a 1986 T25 with a 1.9dg engine that was in pieces separated from the gearbox (someone had stripped it down years ago due to head gasket failure and not rebuilt)
I have now rebuilt the engine and its ready to go in however a lot of the fixings were missing and i have managed to source replacements online but the problem I have now is I cant seem to find the correct nuts and bolts for attaching the engine to the gearbox bell housing.
The engine has 2 studs already fitted at the bottom I assume these just push through the bell housing and then M10 size nuts secure on the bell housing side.
but what fixes at the top I assume a very long nut and bolt of some kind?
also what sort of bolts for bolting the moustache bar to the van?

sorry its a bit of a ridiculous question but i have googled for hours and cant find anything that's definite.

Thanks

https://club8090.co.uk/forum/viewtopic.p ... d#p8124560" onclick="window.open(this.href);return false;
http://www.ekmpowershop16.com/ekmps/sho ... 2230-p.asp" onclick="window.open(this.href);return false;

engine at top m10 if I remember one side just hex head the other with starter motor is a long cap head.

The top bolts are M10x90 hex head for the left side and M10x120 Allen head for the right side. Mounting bar are 4x M8x30 + nuts and washers

Excellent thanks for your replies and thanks for the heads up about the load spreaders, I had no idea about those.

Sent from my HTC One using Tapatalk

don't forget high tensile bolts for the moustache bar.