Club 80-90 Forums

They are 7J X 15 H2

I believe the offset is 35 and the stud pattern is 5/112.

Also what tyre size do i need, do i need extenders or larger bolts.

all so confusing.

You have got further than I have, every time I look at some wheels I think will fit, someone will tell you they don't or you need to do this or that. I hope they fit, you seem to have the right sizes and yes you probably will need longer bolts

I know what you mean, I still can't get these to fit, this lot were no help either

lol looks like where im going

But are they up to standing the weight of a 2 ton van????????

They were off a T4 so i hope so.

G

I think the centre bore is different.

60 sovs to bore a set of four

They only have a slight lip thats not 67 (see photo), do i still need to drill?

Untitled by Garry Moore, on Flickr

Looks like the wheel bolts have been put on with a lump hammer.

That's just the photo angle.

Thanks Rob. Made me chuckle.

R0B wrote:Looks like the wheel bolts have been put on with a lump hammer.

Nice looking wheel. They will refurb ok.

PS have you offered them up to your van yet? Its up front that presents all the "challenges"
I would say get some conversion studs for the front,so you have wheel nuts all round.
Do you have the matching nuts? Conical or spherical seating?

The wheel bolt holes are Conical.

The measurement from bit that touches the hub to the face of the wheel is 50mm

The wheel thread gap from the bit that touches the hub tothe conical is 10mm
The spacer will be either 5mm or 6mm.

What studs and bolts do I need?

G