Club 80-90 Forums

Well needs must

it belongs to a good mate of mine and as hes all into paint not spanners i m doing this as a favour,plus its a change from welding though i still manage to get the cutter and torch out
the problem ... click img for video

it really does make it a sloppy drive

past repair

so cutting

and welding

coating

and the new bearing and carrier fitted

rest tonight
mm

he should notice a massive improvement there I reckon

just ditch all that rubbish and do a single cable, a bracket under the floor to hold the outer cable and run the cable straight to the rear...makes the pedal much more responsive

Well prob right there but not my van and thats what he wants so thats what he gets,

and the biz end

and now a short vid showing the difference, ive added a line to the shaft to show rotational movement click on picky,the computer literate would add click me to the pick , beyond my ability im afraid

the boots are not over the spherical bearings as ive to check adjusments without getting clagged up with it...
this end is 'as was',cable is only temp held in a connector before i terminate it whaen its set correct

its posh in here

ive just rebuilt the steering box on this one so it will be a revelation from half a turn of slack and a floating throttle
mm