Club 80-90 Forums

Hi everyone this is my first post/advice.
I have a T25 Autosleeper 1990 and am looking at getting a towbar fitted however I do not want to cut the rear valance.
I would ideally like one that detaches, has anyone out there got such a thing or have made/ changed one to fit.
Look forward to your input.
Thanks

soxstaffy wrote:Hi everyone this is my first post/advice.
I have a T25 Autosleeper 1990 and am looking at getting a towbar fitted however I do not want to cut the rear valance.
I would ideally like one that detaches, has anyone out there got such a thing or have made/ changed one to fit.
Look forward to your input.
Thanks

Just put one on mine, you don't have to cut the rear valance, it fits inside the chassis behind the bumper

Steve

Steve

Was this on a T25 with big bumpers?

soxstaffy wrote:Steve

Was this on a T25 with big bumpers?

Yes just needed a small square cutting out of bumper underneath, however my bumper is fibre glass and it had a tow eye, the big bumper brackets need modifiying, slit the box section on bracket and remove tow eye you need to remove the two captive nuts on each bracket of the big bumper this allows you to slide these brackets over and down the outside of your towbar which should have captive nuts with a 12mm thread the old bumper brackets serve as packers allowing you to tighten things up nicely, I did have to fit a drop plate to the towbar as it was to high by about 50mm for the caravan. Hope that is of some use to you
Steve