Club 80-90 Forums

Does anyone know where I can get a new / replacement carburetor for my 1980 air-cooled 1600 T25 ?

Not available new but earlier Bay window carburettors can be adapted with some parts off the old carburettor. Why do you need to change it? Unless it has a cracked or corroded body they can easily be repaired/refurbished.

Just had MOT and service - all good after a year of having things replaced and updated but the garage said the carb had 'seen better days' and they had patched it up but ideally I should have it replaced. They are my local garage, I know them well and trust their judgment, done my car for years and very appreciative of my van.

Try these folk. Remove it and send it in the post

http://www.dellorto.co.uk/contact.asp" onclick="window.open(this.href);return false;

There are plenty of carb specialists who can refurbish the carb as double 7 listed above and Gower and Lee, Southern Carburettors.
Where abouts are you ?

Ring Roger Ball in Clacton. He knows V-dub carbs and will advise you. He does mail order and can rebush it for you (the only wear there is) and when it comes back, fit a gasket kit. If you ring him, tell him Ralph gave you his number.



The others are good but it could cost a lot more. Lots on here have used him.

Thank you everyone, this is all helpful and I will follow up on these leads. I'm in Shropshire, by the way!

Gasure refurb carbs, they are over the border in Chester.

http://www.gasure.co.uk/contact.htm" onclick="window.open(this.href);return false;

Thanks again, I'm currently following them all up!