Club 80-90 Forums

Are there any new gadgets to remove these?

Other than vise grips and plus gas..

thanks.

i got one out with some irwin extractors, you know those sockets for rounded off heads

lloydy wrote:i got one out with some irwin extractors, you know those sockets for rounded off heads

cheers mate, never thought of that.
Didn't think they went down that small

I tend to use a box spanner with a suitable bar so that you put pressure in two directions instead of just wringing the damn thing off with unequal force! They should be stainless as standard.

Try knocking a torx bit in to the hole but don't be violent and break it off or you'll be knackered

sorted.
used a 6mm socket hammered it on.. and plus gas.

It's when it turns easily first time it is time to panic - did it shear off or did it just open. I hate the pesky little things.

Oldiebut goodie wrote:It's when it turns easily first time it is time to panic - did it shear off or did it just open. I hate the pesky little things.

it just opened...lucky this time

I am sure that I sourced some stainless one for one of my vehicles, I have a feeling that they were motorcycle ones. As these are on show all the time they were produced in the stainless.