Club 80-90 Forums

Hi Folks,

I have a lovely brown T25 westy club joker but I have two wee holes I need to fill . Can anyone tell me what should go in them (and does anyone know where I can get one?)

In this picture you can see a hole on the sliding door and on the panel behind the seat. The sliding door hole has a square profile shaft sticking out with a tapped hole in the center. This has been identified as a second sliding door handle. Thanks horizontal kipper.
This hole has two threaded holes (one directly below the left edge of the hole and the other above and to the right of the right edge.

Any help with these would be greatly appreciated.

Not positive..but doesn't the Ebberspacker blow heater Control switch normally fit around this area.

Martin

I would put a window winder on that square shaft and see what happens when you turn it.

This being a club joker there should be a night heater control there.

Ah, someone has pulled the night heater from my van. Does anyone have a picture or part number for the control? I would like to get the heater back in. I went camping last may for my birthday and I was ill and freezing.

marlinowner wrote:I would put a window winder on that square shaft and see what happens when you turn it.

It won't take a window winder but it should take a spanner. I'll see what happens and post the result. I guess no one else has seen one of those?

mikeybjettaman wrote:Ah, someone has pulled the night heater from my van. Does anyone have a picture or part number for the control? I would like to get the heater back in. I went camping last may for my birthday and I was ill and freezing.

I have a controller that fits in there you can have for now't I'm only down the road in Northwich if you want to pick it up or I will meet you halfway p.m. me

Door handle to pull your sliding door shut and Eber control.

horizontal kipper wrote:Door handle to pull your sliding door shut and Eber control.

Is it so you can pull it in quietly instead of using the momentum of sliding?

California Dreamin wrote:Not positive..but doesn't the Ebberspacker blow heater Control switch normally fit around this area.

The thermostat and switch for the Eber's there, but the timer's down on the front of the under-bed box.

manxblade wrote: I have a controller that fits in there you can have for now't I'm only down the road in Northwich if you want to pick it up or I will meet you halfway p.m. me

Cheers for that manxblade. I'll look forward to meeting soon.

Jim San wrote:

horizontal kipper wrote:Door handle to pull your sliding door shut and Eber control.

Is it so you can pull it in quietly instead of using the momentum of sliding?

I would guess it might be. The door would have to be mostly closed to be able to get at it. Good thinking and cheers for your help.

mikeybjettaman wrote:

manxblade wrote: I have a controller that fits in there you can have for now't I'm only down the road in Northwich if you want to pick it up or I will meet you halfway p.m. me

Cheers for that manxblade. I'll look forward to meeting soon.

Jim San wrote:

horizontal kipper wrote:Door handle to pull your sliding door shut and Eber control.

Is it so you can pull it in quietly instead of using the momentum of sliding?

I would guess it might be. The door would have to be mostly closed to be able to get at it. Good thinking and cheers for your help.

yes my early joker has the handle.

horizontal kipper wrote: yes my early joker has the handle.

Could you post a picture of it? I guess its not the same as the other interior sliding door handle.

manxblade wrote:

mikeybjettaman wrote:Ah, someone has pulled the night heater from my van. Does anyone have a picture or part number for the control? I would like to get the heater back in. I went camping last may for my birthday and I was ill and freezing.

I have a controller that fits in there you can have for now't I'm only down the road in Northwich if you want to pick it up or I will meet you halfway p.m. me

Hi Manxblade,

I PM'd you but I've not had a relpy. Is your controller still available?

mikeybjettaman wrote:

horizontal kipper wrote: yes my early joker has the handle.

Could you post a picture of it? I guess its not the same as the other interior sliding door handle.

Exactly the same handle on mine but goes horizontally not vertically like the front one.