Page 1 of 1
Ford Alloys figment requirements
Posted: 08 Sep 2014, 22:17
by MattBW
I've got a set of these and I'm told they will fit a t25 without too much to trouble.
Anyone fitting any and know what I need to do to use them? Or is it a bad idea?
Re: F0RD Alloys figment requirements
Posted: 08 Sep 2014, 23:02
by kit
If that says 87v then the tyres are not load rated for a van.
Re: F0RD Alloys figment requirements
Posted: 09 Sep 2014, 00:04
by MattBW
Cheers. Would the wheels be any good with new tyres?
Re: F0RD Alloys figment requirements
Posted: 09 Sep 2014, 14:15
by kevtherev
It's doubtfull..what are they off?
Re: F0RD Alloys figment requirements
Posted: 09 Sep 2014, 15:36
by crazydiamond
If they are Granada scorpion, they are most likely 5 x 112. so could fit with the correct load rated tyres, may have to open holes up to clear M14 bolts though., they sometimes get used on syncros. but you have to make sure the centre bore is big enough to clear on a T25
F0RD Alloys figment requirements
Posted: 10 Sep 2014, 12:56
by MattBW
I believe they are Granada wheels yes, May et the tape measure out and have a look. Cheers.