Club 80-90 Forums

hi, well after the syncro jx dropped a valve and mashed the head and piston and the fact that i have a full 1z use up lying around, I've decided to do the conversion. I firstly was going to replace the fly by wire pump with a mechanical pump but have now decided to use the fly by wire. Does anybody know of any how too instructions on the wiring loom, or wiring diagram or where i can buy a loom of the shelf to speed up installation, i want the van running for harwood house meet in a couple of weeks even though i know its a long shot. thanks again wozza.

I managed to find a good guide on the t4, t5 forum how to split the loom, there will be some minor bits different i think, but very clear instructions.