Club 80-90 Forums

WEhey.... Need some bits to convert my intake system to a DG Pierburg Carb .... So ....
I just bought a 2nd Hand engine with most of the bits n' bobs still attached .. I DO NEED a new plastic oil filler tube [mines cracked at bottom, has jubilee clip + pishes oil out !] and Lo + Behold .. the latest lump has a good un !
Anyway.... cut to the chase ... How is it fitted onto the lower metal pipe ??
how do i get it off ?? and will it go straight on my Lump /?????

Im assuming its a kinda push fit + just pulls off, but i have just dropped the lump off on m8's workbench .. and had no time to play ! !

Will start pulling bits off - apart on friday ............. ave' it .........

doh ....... DOH ....... DOH .......

Meant to put this in Tech Help !! Not Chittychatty Section .. apologies .. and if Mod' team want to move .. Feel Free !

Mind... theres more chat than tech in content ....
\

change it at the metal end, onto the injun!
they never go back on any good if you seperate them at the plastic bit......



i moved this!

Mocki ... Gasket ?????????

Yes use a new gasket and a smear of sealant... or it will "pish" out.......

Ta ...........

I was talking to mocki about this the other day, he recommended general purpose grease, on both sides of gasket, do it up max hand tight