Club 80-90 Forums

Hello anyone any ideas on my drivers door lock it won't open with key I can pull the knob up from inside though. Cheers

Is it gunked up? try a tiny squirt of WD or +gas

Tried wd but no joy

Is the key moving in the lock? describe the symptoms.

No key not moving at all when I bought van it was a bit temperamentall then at some point just stopped working put knob inside van lifts up and down fine by hand when door is shut

If key can be inserted but won't turn it will be plungers sticking or plunger spring/s broken, prob the former. you can remove and dismantle to clean and lube

Is that in the handle it's self then or in the workings in the door card

plungers in the round barrel part that key goes into. the barrel then sits in black handle. the barrel has spring loaded plungers which engage in slots in the body of black door handle and thus prevent barrel turning till a key is inserted then plungers retract into the barrel out of the slots and thus allow barrel to turn/unlock

http://www.hallvw.clara.net/lockpart.htm" onclick="window.open(this.href);return false;

hey there. new to the forum and a new owner of a 1985 T25. I've been trying to fix the locks on my van as they appear to have the same problems as listed above. But I'm having no luck removing the cylinder from the whole handle. Do you know if it's supposed to come out the back or the front of the handle? It's pretty gunked up so maybe I need to use degreaser? Thanks in advance from Reykjavík, Iceland.

Look for the tiny grubscrew.

billdylan wrote:hey there. new to the forum and a new owner of a 1985 T25. I've been trying to fix the locks on my van as they appear to have the same problems as listed above. But I'm having no luck removing the cylinder from the whole handle. Do you know if it's supposed to come out the back or the front of the handle? It's pretty gunked up so maybe I need to use degreaser? Thanks in advance from Reykjavík, Iceland.

You have to get access to the back of the handle
Sliding door lock has a tiny grub screw (flat blade)
Front doors have a tiny pin. (a good quality pin punch is needed)

In both cases the cylinder comes out the front. It is worth putting the key IN the cylinder before removing it.

They may take a bit of wiggling to get them out - a good squirt of WD40 should help