Club 80-90 Forums

Hi, my hob is a slightly raised one which is great for cupboard space underneath but leaves me a bit short on work top space. I'd like to get a piece of smoked glass cut to size with the correct radius corners and hinge holes drilled which I can then fit to act as both a work top in the "down" position and a splash guard in the "up" position. Any recommendations for suppliers?

Thanks!

My local glass supplier is good at that sort of thing - don't try a window supplier as they don't have the expertise with different types of glass. Mine cut and shaped a smoked toughened glass coffee table top in next to no time.

Oldiebut goodie wrote:My local glass supplier is good at that sort of thing - don't try a window supplier as they don't have the expertise with different types of glass. Mine cut and shaped a smoked toughened glass coffee table top in next to no time.

Thanks....you're not too far away from me...got contact details for them?

A couple of 100 miles away! You must have someone in the Lincoln area.

Ooops sorry read it as East Anglia! Yup found a local chappie...

I have one spare, it's just missing the hinges as they were bent but I'm sure you could invent something, do you want a pic of it and measurements?

Thanks I'll certainly take a look at the dimensions - it'll be a right result if it fits but I can't imagine I'll be that lucky as mine will need rounded corners to a very specific radius to sit how I want it to...

It's 46cm by 42cm and the pic can be seen on the link below;

https://onedrive.live.com/redir?resid=2 ... oto%2c.jpg" onclick="window.open(this.href);return false;

Hopefully this helps,

Adam.