Club 80-90 Forums

Morning all,
I need to change the gear linkage bushes on my van. I changed the front one at the stick a while back which helped but I need to do the rest, I have had a look at the wiki. Is it a job you can do on the ground or does it need to go up in the air? and does anyone have a link to or the best place to get the kit from please?
Cheers
Gypo

Brickwerks, ebay, lots of places for kits. Jacking up van, yes a bit, even more if you're as big as I am....

CovKid wrote:Brickwerks, ebay, lots of places for kits. Jacking up van, yes a bit, even more if you're as big as I am....

Many thanks, Ill get it ordered, Is it a long job to do, assuming it goes ok?
Cheers
G

Is this all I need as I have done the front?
http://www.ebay.co.uk/itm/VW-CAMPER-T25 ... 2c6077b8f0
Cheers
G

Anyone please?
Cheers
G

I think there are a few more bits than that, bush in the support on the gearbox and a joint halfway

They are in that kit. Some models use two identical bushes. Should be OK though. Have a nose at 4 or 5-speed linkage WIKI section as you'll see which bushes go where.

Cheers People.
G