Page 1 of 1
What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 15:38
by sciroccotune
Hi guys,
As my trip approaches I start to remember all the things I'm meant to have done but have forgotten!
One such thing is to work out how to connect a gas BBQ to the underslung has tank on my westy.
It has what seem to be like an additional outlet near the isolation valve but can anyone tell me a bit more about what I should look for and need?
Cheers guys

Re: What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 16:40
by Fumar
http://www.ebay.co.uk/itm/251378253625? ... 1439.l2649
I think its one of those.. at least I hope it is.. I bought one for the same reason. Haven't tried it yet..
If its not I'm sure someone will put me in my place.. again.. I'm usually wrong..
Re: What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 20:15
by sciroccotune
Thanks bud, although my tank doesn't have an outlet for that
Does yours look like this? -
ImageUploadedByTapatalk1400616928.439575.jpg
Re: What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 20:45
by clift_d
Your regulator setup looks different to the one on our van - perhaps the regulator has been replaced in the past and the BBQ point was removed when that was done.
The setup on our van looks more like this:
The BBQ point is under the plastic cap at the far left.
Re: What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 21:28
by sciroccotune
clift_d wrote:Your regulator setup looks different to the one on our van - perhaps the regulator has been replaced in the past and the BBQ point was removed when that was done.
The setup on our van looks more like this:
The BBQ point is under the plastic cap at the far left.
That's very interesting, thank you! They look very similar but I agree I'm missing the BBQ point - sad times!
Well I don't think I will have time to have a BBQ point fitted so looks like charcoal for us...
Out of interest has anyone installed a BBQ point or new regulator?
Cheers
Re: What do I need to fit a gas BBQ outlet?
Posted: 20 May 2014, 21:42
by clift_d
Günzl in Germany sell new 50mbar regulator sets including the BBQ point, see here:
http://www.vwbusshop.de/epages/GuenzlCl ... F255070439
I wouldn't imagine that it would be too much for a gasure fitter to swap them over.
I believe the regulator does need to be 50mbar for the original Westy fridge to work properly.