Club 80-90 Forums

I have just fitted a silicon water hose from Brickwerks and I am very pleased how easy it was and how well made it looks, I have trawled through the post on here but I can't find any opinions on them i.e. longevity or suitability, am I the only one to fit them?

i might have fitted some.......

I can see from that I am going to have to replace a few more, my existing ones do not look like that, mine are in sections with jubilee clips everywhere

I did the hoses and fitted the s/steel front to back pipes at the same time, expensive but peace of mind.
So have you cut in a repair piece, or fitted a complete hose

I fitted the piece in the top right of your first photo, it was almost half the cost of a rubber one from JK, what engine is that btw?

It's a 1.9 TDI (AFN)

Why is there not a hose from your expansion tank?

Only because the pic was taken while filling it up

lots of unnecessary clutter in there
mm

Why oh why are they always made in chavvy Saxo boy racer colours What's wrong with black !

metalmick8y wrote:lots of unnecessary clutter in there
mm

Your like the aggy and Kim of engine bays!

ghost123uk wrote:Why oh why are they always made in chavvy Saxo boy racer colours What's wrong with black !

I chose that colour... They do have black.. And any colour you happen to want.

lloydy wrote:

ghost123uk wrote:Why oh why are they always made in chavvy Saxo boy racer colours What's wrong with black !

I chose that colour...

Actually now as I think about it, I quite like it

lloydy wrote:They do have black.. And any colour you happen to want.

Good to know

just as some folk prefer plant bread and mass market beer to artisan loaves and bespoke brews
mm
that said the plant bread is as good as any for toast and beans

Thank god it's not chrome, it would never have hot me home