Club 80-90 Forums

Have been meaning to start a post about the 'freshening' of my bus for ages but it's been ongoing for a while, being a tech I'm too busy fixing other peoples cars than finding time for Jessabelle! The viscous cycle!
The engine is out as it had a ring problem on cyl 1. Her body isn't that bad compared to some posts on here but am under no illusion it may get worse the deeper I get. Here's a few photos to get it going

Any advise is welcome, and will update when I can or have done something new

nice SA bumpers on there... is it an early SA van?

Shows how little I know, uk van as far as I'm aware will check the vin and work it out

Nice brake up grade.

Just don t leave any rotten rusty bits behind,and if you decide to do the panel behind the slider runner/ bottom of window ,I have these ,good luck with it
mm

MM
Are those slider panels made to match the full height arches? And how much?

Yep ,will pm you

here page 9>>>
https://club8090.co.uk/forum/viewtopic.php?f=38&t=114490" onclick="window.open(this.href);return false;
it goes higher up the side and longer but i cut down to fit as needed
mike

Anybody know why the pics have disappeared?

MMs panel is good
I fitted one a couple of weeks ago!
Best of luck with it all!

Freshly powder coated and new powerflex bushes, love them or hate them they do look good!!

Brakes painted and ready for new ball joints etc

Busy ready for MM's slider panel