Club 80-90 Forums

I have seen a nice set of Pentas for sale with load rated tyres etc and was wandering if they would fit my van. Unfortunately I know next to nothing about wheel options and what will/wont fit. Not sure if it is relevant but the van is lowered approx 40mm

This is what is stamped on the wheels Penta, 8J 16H2, P1680 and e11

Gary

This is mine, more info on my other posts about pentas, but mine are 7.5

ET11 = No.

^^^^^^^^^^^ mine in the previous post, are Ronal amg 7.5x16H2 et42' I needed 15mm spacers on the front, so did the same on the rear to keep the same, longer studs on rear, plus longer stud conversion on the front, then fitted these van rated tyres, to keep the rolling circumference the same as the original steels !

The bit I missed off the last post

All done with the knowledgable advice of Steve (g60steve), he is a true expert on all things wheels !

g60steve wrote:ET11 = No.

cheers for that. To be honest I wasn't looking for wheels as such, I just saw them and thought they would look great on my van. You have actually done me a favour by saying they wont fit and taken away the temptation (and a lot of explaining to the Mrs's)

paulgg wrote:
This is mine, more info on my other posts about pentas, but mine are 7.5

They look cracking mate, perhaps Pentas are the way to go when I finally give in a change my standard steels

Thanks, I was damned lucky tbh, someone gave me three different sets of alloys for scrap, amongst them were this set of five pentas, so I refurb end them myself, cost me a set of load rated tyres & a stud kit !! Well happy

You jammy git you did a good job on the refurb, they look like they have come up really nice. Unfortunately I'm never that lucky. I'm definitely going to keep an eye out for some though.

Just hand polished em with peek polish !

I have same, but my pantas are 16x8J

mimiwestfalia wrote:I have same, but my pantas are 16x8J

Looks good on the deeper dish, nice looking van mate