Page 1 of 1

Problems starting

Posted: 15 Oct 2006, 00:06
by sauce1001
Sometimes on turning the key nothing happens, push starts fine everytime. I've checked/cleaned the terminals on the starter motor which seemed to cure it, then 2 weeks later same again. Happens when it's hot or cold.

Any suggestions? Cheers.

Posted: 15 Oct 2006, 08:47
by DiscoDave
whip the starter out, check that the little copper bush is intact, this sometimes causes bother! i'd also have a look along the run of the starter feed, if it is damaged anywhere it may be shorting adn not starting! this happened with mine, right old pain in the preverbial!!